Warning: Last items in stock!
The Strike Industries PDW stock represents the pinnacle of ultra compact PDW systems. At the compressed position, the compact Strike PDW allows for effortless maneuverability particularly in close quarters and vehicular operations. With the press of a button, the rapid deployment system instantly springs to the extended position for greater shot stability. Previous PDW systems for ARs have been notorious for expensive proprietary systems, spotty reliability and poor ergonomics.
The PDW Stock is designed to able to drop into your existing platform. The buffer system is carefully engineered to provide for high reliability while allowing for the use of standard bolt carriers, allowing for multi-role use with a single system. The included flat wire spring increases bolt load despite the compact dimensions for greater reliability, even in extreme short barrel configurations.
In addition to mechanical reliability and performance, we at Strike Industries have also paid close attention to human factors to increase comfort and controllability. The low footprint shoulder weld is shaped to conform to the shoulder pocket for maximum stability and control even in compromised or unconventional shooting positions. Included with the PDW stock is a rubberized cheek rest to create a comfortable cheek weld, a criticism of many competitor PDW systems.
Finally, a PDW stock without compromise. Strike Hard, Strike Fast with the Strike PDW.
-AR-15 Mil-Spec receivers
-Angstadt Arms 9mm & PSA 9mm
-Using a lightweight BCG may cause damage to PDW buffer
-9mm platforms not mentioned above unless you also purchase the Strike Industries AR PDW 9mm Buffer
-Large frame AR. (LR308, AR10, etc.)
DISCLAIMER: Due to the compact design of the PDW Stock and PDW Stabilizer, the SI Extended, Shift & Ultra Light Pivot / Takedown Pins, as well as other possible extended pin sets on the market, will bind or not clear the slide rods.
Recommended tool for installation. Please use painters tape or like item on tool so you do not scratch the coating on the PDW castle nut:
- 1x Strike PDW Stock Assembly
- 1x Strike PDW Buffer Assembly
- 1x Strike PDW Buffer Tube
- 1x Strike PDW Flat Wire Buffer Spring
- 1x Strike PDW Castle Nut
- 1x Strike PDW Cheek Rest
- Ambidextrous, push button deployment
- (Patent pending) Ergonomic, compound curved stock
- Compatible with standard bolt carriers
- No non-standard take down procedures
- Compatible with many ambidextrous lower receivers such as the SanTan and Rainier Arms.
- Built in QD attachment
Information: To buy firearms and essential elements, you must have or be able to obtain a weapon permit (WES/SON/PAA/PAE) in Switzerland according to. (Art. 8 al. 1 LArm and ss and art. 15 al. 1 ss OArm)
If you fulfill this requirement and you purchase a firearm, please send us the WES / PAA to the following address: Dynamik Arms SARL/Gmbh, 124 route d Annecy, 1257 Croix-De-Rozon Suisse
To Buy ammunition, we will need a copy of of less than 2 years old weapon permit (Waffenerwerbschein (WES / PAA)) with the same caliber as the ammo purchased that can be simply sent pdf by e-mail.
WARNING: If you don't have such permit or have doubt on the possibility to obtain one, don't purchase the firearm, essential element or ammunition since we you will have a penalty of 30% of the firearm, essential element or ammunition sum for admin costs.
Leupold Optics: For all Mil/LE and Government Entities only. Please submit valid accreditation
Export notice: Certain items are controlled for export by the International Traffic in Arms Regulations (ITAR). These controls take the form of export regulations and license requirements.